News

News

News

Home / News
  • Temperature control method of busbar machine

    Temperature control method of busbar machine

    The precision of the bus processing machine is to meet the needs of high-tech development, but also to improve the performance, quality and reliability of ordinary electromechanical products, reduce the workload during assembly, and improve assembly efficiency. The busbar bending machine is at a high potential. At present, there are very few instruments dedicated to […]

  • Brief introduction of matters needing attention when using bus processing machine

    Brief introduction of matters needing attention when using bus processing machine

    Precautions when using bus processing machine: Stop the machine when changing the mould to avoid danger. During operation, be careful when holding the workpiece and waiting for the slider to go down As the busbar bending machine can be operated by more than one person, a special person must be assigned to direct the production […]

  • The daily maintenance of CNC bus bar machine

    The daily maintenance of CNC bus bar machine

    The following article helps you to explain the relevant maintenance of bus processing machine: a: Before using the busbar bending machine, read the manual carefully, turn on the power, and confirm the positive and negative rotation of the motor b: Add anti-wear hydraulic oil (select brand 46 hydraulic oil, the oil should be clean and […]

  • Operation principle of power cut and transmission for transformer of bus processing machine

    Operation principle of power cut and transmission for transformer of bus processing machine

    What is the operation principle of the power cut and transmission of the transformer of busbar bending machine? Let’s understand: 1) Before stopping and transmitting power, the neutral grounding switch must be closed, and the zero sequence protection should correspond to the neutral grounding mode of transformer 2) The transformer must be put into and […]

  • Common faults and troubleshooting of bus processing machine

    Common faults and troubleshooting of bus processing machine

    The fault of the busbar bending machine can be divided into circuit fault, mechanical fault and hydraulic system fault. In the process of using, the machine tool fault caused by hydraulic system is common, among which the fault of hydraulic circuit can depend on each other. When removing the fault, we should combine the circuit […]

  • Maintenance plan of busbar machine

    Maintenance plan of busbar machine

    In order to ensure the normal operation of Party A’s machine and extend its service life, it is necessary to carry out a maintenance. Our company will carry out maintenance on Party A’s agreed equipment on site. The specific maintenance contents are as follows (Table 1) Hydraulic part Check the hydraulic oil level. If the […]

  • Requirements for installation site of busbar machine

    Requirements for installation site of busbar machine

    Please choose a busbar bending machine spacious, clean and level place and pay attention to the following: 1. Within the moving range of materials, avoid obstacles to avoid accidents. 2.The place space of the equipment should be able to carry out maintenance, repair and other operations, and the height should be 1500mm higher than the […]

  • Matters needing attention when bus bar equipment needs to be transported

    Matters needing attention when bus bar equipment needs to be transported

    1.When the machine needs to be lifted during transportation or installation, it should be hung on the special lifting bolts under the machine with qualified lifting tools (Note: the lifting bolts must be tightened). Special requirements: pay attention to the overall balance of the equipment when lifting, and ensure that the equipment will not be […]

  • Requirements for adding and discharging hydraulic oil for busbar machine equipment

    Requirements for adding and discharging hydraulic oil for busbar machine equipment

    The busbar bending machine is equipped with automatic oil filling and discharging device. The following is a brief description of the use of the problem: Open the tool box, insert one end of the hose into the oil filling port, and put the other end into the new oil barrel. Put the switch in the […]